Question 655General Subjects - Assistant Engineer
70% to passFailing to decrease the feed pressure on a drill as its point begins to break through the bottom of the work piece will cause the drill to _______________.
Abreak cleanly through the bottom of the work piece
Bform a tapered hole in the bottom of the work piece
Ccut an elongated hole in the bottom of the work piece
Djam in the work piece and tend to whirl it around
AI Explanation
The correct answer is D) jam in the work piece and tend to whirl it around. When drilling through a work piece, it's important to decrease the feed pressure as the drill point starts to break through the bottom. Failing to do so will cause the drill to jam in the work piece and potentially whirl it around. This can damage the drill, the work piece, and be dangerous for the operator. The other answer choices do not accurately describe what happens when the feed pressure is not reduced in this situation.
Related Questions
Q560:For a pneumatic transmission system for instrumentation purposes, if a pneumatic... Q38:In a twin-tower desiccant type air dryer using silica gel as an adsorbing agent,... Q402:When repacking a reciprocating pump with more than four rings of packing, the pa... Q352:Which set of operating conditions would be most problematic in terms of the dete... Q44:Which of the following causes would most likely result in excessively high belt-...
Ready to test your knowledge?
Take a General Subjects - Assistant Engineer Practice ExamOfficial Resources