Question 654General Subjects - Assistant Engineer
70% to passBefore drilling a hole in a piece of metal, the location of the hole center should be _______________.
Amarked with chalk
Bblued
Cscribed
Dcenter punched
AI Explanation
The correct answer is D) center punched. Before drilling a hole in a piece of metal, the location of the hole center should be center punched. This creates a small indentation at the exact spot where the hole is to be drilled, which helps to guide the drill bit and prevent it from wandering off the intended location. Center punching is a common and recommended practice in metalworking to ensure accurate hole placement. The other options are not as effective for preparing the hole location. Marking with chalk would be temporary and easily wiped away. Bluing the surface does not create a physical indentation. Scribing a line can indicate the general area but does not precisely mark the center point.
Related Questions
Q344:What statement is true concerning the purpose of an independent main thrust bear... Q342:What statement is true concerning the lubrication of line shaft bearings? Q2:In order to take suction on the lube oil drain tank cofferdam with the bilge pum... Q20:The device shown in the illustration is used to _______________. Illustration GS... Q3:The emergency bilge suction valve is typically used _______________.
Ready to test your knowledge?
Take a General Subjects - Assistant Engineer Practice ExamOfficial Resources