Question 281General Subjects - Assistant Engineer

The correct answer is A) The areas dimensioned 0.64 in length are flats on the shaft. This is the correct answer because the illustration shows a shaft with flat areas dimensioned at 0.64 inches in length, which are commonly referred to as "flats" on a shaft. Flats are intentionally machined areas on a shaft that are flat rather than cylindrical, typically used for securing components such as pulleys or gears. The other options are incorrect because they do not accurately describe the features shown in the illustration. Option B is incorrect as the 0.64 inch areas are not steps in the shaft diameter. Option C is incorrect as there is no information provided about threaded ends or longitudinal tolerance dimensions. Option D is incorrect as the 0.03 inch undercuts are not relevant to adjusting lengths to meet specified tolerances in this case.