Question 238General Subjects - Assistant Engineer
70% to passThe line labeled "G", as shown in the illustration would be identified as the _______________. Illustration GS-0175
Awaste oil outlet line
Bprocessed water outlet line
Cclean water inlet line
Doily bilge water inlet line
AI Explanation
The correct answer is A) waste oil outlet line. The illustration GS-0175 likely depicts a typical oil/water separator system found on many marine vessels. The line labeled "G" would be the waste oil outlet line, which carries the concentrated oil from the separator to a waste oil storage tank or overboard discharge. The other answer choices are incorrect because: B) is the line for the processed (cleaned) water exiting the separator, C) is the clean water inlet line feeding the separator, and D) is the oily bilge water inlet line entering the separator.
Related Questions
Q322:Which of the following propulsor types would be used with unidirectional propuls... Q47:If a reciprocating air compressor has cylinder suction or discharge valves that ... Q129:While circulating heated sulfuric acid through a feed water heater of a flash ev... Q663:Hydraulically, servo-operated, automatic, change over valves, utilized in a two ... Q73:After adding grease to a ball bearing with a hand-held grease gun, you should __...
Ready to test your knowledge?
Take a General Subjects - Assistant Engineer Practice ExamOfficial Resources