Question 117Motor Plants - 1st Asst/Chief
70% to passWhile operating the fuel oil centrifuge shown in the illustration, the fuel oil is being continuously ejected with the sludge and the seal water. The probable cause is the_______________. Illustration MO-0012
Agravity disk inside diameter is too small
Bgravity disk inside diameter is too large
Cback pressure is too low
Dincorrect number of disks have been placed in the disk stack
AI Explanation
The correct answer is B) the gravity disk inside diameter is too large. When the fuel oil is being continuously ejected with the sludge and the seal water, it indicates that the separation process is not efficient. This can be caused by the gravity disk inside diameter being too large, which results in insufficient centrifugal force to properly separate the fuel oil from the sludge and water. The other options are incorrect because: A) a smaller gravity disk diameter would increase the centrifugal force, improving separation; C) low back pressure would not cause the continuous ejection of fuel oil; and D) the number of disks in the stack is not the issue, as the problem is with the disk diameter itself.
Related Questions
Q30:If the speed of the propeller is 135 RPM, the speed of the engine camshaft shown... Q204:The principal hazard to personnel when using a diesel engine fuel nozzle tester ... Q93:Fuel combustion in a diesel engine cylinder should begin just before the piston ... Q56:In a Bendix starter drive, the pinion engagement with the flywheel ring gear is ... Q155:Which of the following devices will increase the power output of a diesel engine...
Ready to test your knowledge?
Take a Motor Plants - 1st Asst/Chief Practice ExamOfficial Resources