Question 282Motor Plants - Assistant Engineer
70% to passWhere does the shoot cycle operating liquid first come in contact with the rotating forces of the device shown in the illustration? Illustration MO-0112
AWhile traveling under disc stack "N".
BAt the inlet cone labeled "O".
CIn the opening chamber labeled "L".
DAt the inlet orifice labeled "S".
AI Explanation
The correct answer is C. In the illustration MO-0112, the shoot cycle operating liquid first comes in contact with the rotating forces of the device in the opening chamber labeled "L". This is the correct answer because the operating liquid enters the device through the inlet cone labeled "O", and then flows into the opening chamber labeled "L" where it encounters the rotating forces of the device. The other options are incorrect because the liquid does not come into contact with the rotating forces under the disc stack "N" (option A), at the inlet orifice labeled "S" (option D), or at any other location in the device.
Related Questions
Q178:Which type of starter motor is normally used in a diesel engine hydraulic starti... Q496:When an additional load is applied to a diesel engine which is using an inadequa... Q77:What prevents the thrust bearing blocks shown in the illustration from rotating ... Q284:The item indicated by the letter "F" of the device shown in the illustration is ... Q486:If sludge accumulates on the underside of a diesel engine piston, it will ______...
Ready to test your knowledge?
Take a Motor Plants - Assistant Engineer Practice ExamOfficial Resources