Question 334General Subjects - QMED
70% to passWhich of the following descriptions should be included when identifying the length for pipe nipples?
AStandard, extra-strong, double extra-strong, and schedule 80
BClose, short, long, and tank
CCast, wrought, stainless, and brass
DFully threaded, half threaded, long, and short
AI Explanation
The correct answer is B) Close, short, long, and tank. When identifying the length for pipe nipples, the standard descriptions used are close, short, long, and tank. These terms refer to the length of the threaded portion of the pipe nipple, with close being the shortest and tank being the longest. The other options are not the appropriate descriptions for pipe nipple lengths. Option A) refers to the wall thickness or schedule of the pipe, option C) describes the material composition, and option D) is not the standard terminology used for pipe nipple lengths.
Related Questions
Q164:To check the thickness of a piece of thin shim stock before using it to make a b... Q70:Which of the listed substances can be satisfactorily removed from diesel fuel by... Q251:The pressure of a liquid leaving the pump can be referred to as the ____________... Q235:Which of the following types of nuts would be best suited to use when it is impo... Q244:To get an accurate measurement using a 12 inch machinist's steel rule, you shoul...
Ready to test your knowledge?
Take a General Subjects - QMED Practice ExamOfficial Resources