Question 233General Subjects - QMED
70% to passWith regards to the American National Screw Thread nomenclature, 'pitch' is the _______________.
Aangle of taper formed by the centerline of the screw and the crests of the thread
Bangle formed by adjacent flanks of a thread
Cnumber of threads divided by the length of the threaded portion of the screw
Ddistance between corresponding points on adjacent threads
AI Explanation
D) Distance between corresponding points on adjacent threads is the correct answer. The pitch of a screw thread is defined as the distance between corresponding points on adjacent threads, such as the distance between the crests or valleys of adjacent threads. This is the key defining characteristic of the thread pitch. The other answer choices are incorrect: A) The angle of taper is a separate thread parameter known as the thread angle. B) The angle formed by adjacent flanks is another thread parameter known as the thread angle. C) The number of threads divided by the length is a different thread parameter known as the threads per inch (TPI).
Related Questions
Q273:Which of the lubricants listed is the best to use on a reciprocating pump rod? ... Q357:The clutch band of a constant tensioning mooring winch must be set up tight enou... Q172:For greater accuracy, some micrometers have a vernier scale making it possible t... Q239:Which of the instruments listed is used to measure the gauge of a piece of sheet... Q299:Which of the following valve arrangements permits the reciprocating pump liquid ...
Ready to test your knowledge?
Take a General Subjects - QMED Practice ExamOfficial Resources