Question 104General Subjects - QMED
70% to passWhen installing DANGER tags when performing a tag-out and lock-out procedure in preparation for accomplishing maintenance, what is the color of these tags?
AOrange
BRed
CYellow
DGreen
AI Explanation
The correct answer is B) Red. The color red is used for DANGER tags when performing a tag-out and lock-out procedure, as it signifies a hazardous condition that could result in serious injury or death if the equipment is operated. This is in accordance with the Occupational Safety and Health Administration (OSHA) regulations, which specify the use of red tags for DANGER when conducting maintenance or servicing activities. The other options are incorrect because orange, yellow, and green tags are used for different purposes, such as CAUTION, WARNING, or INFORMATION, respectively, and do not carry the same level of hazard as the red DANGER tag.
Related Questions
Q237:To set the dividers to the proper radius, you should use a _______________. Q56:Which of the valves listed for the device shown in illustration will be open whi... Q293:Excessive air leakage into the suction side of a centrifugal pump would be indic... Q214:In order to tighten the bolts of a crank pin bearing to the exact tension specif... Q300:The suction-force principle of operation is a typical characteristic of ________...
Ready to test your knowledge?
Take a General Subjects - QMED Practice ExamOfficial Resources