Question 185General Subjects - 1st Asst/Chief
70% to passWhile making a round in the lower engine room you discover a leak in the suction pipe to the main salt water pump. How would proceed to correct this problem?
AUse a type of banded patch (from a simple gasket with hose clamps to forge clamp style) on the pipe to seal the hole in the pipe until a permanent repair can be made.
BWrap the leaky section of pipe with duct tape to slow the leak down.
CLet the pipe leak until a permanent repair can be made at your next port call.
DMonitor the leak to see if it worsens.
AI Explanation
The correct answer is A) Use a type of banded patch (from a simple gasket with hose clamps to forge clamp style) on the pipe to seal the hole in the pipe until a permanent repair can be made. This is the correct answer because it is the appropriate procedure to temporarily stop a leak in a suction pipe in the engine room, as per industry standards and regulations. A banded patch is a quick and effective way to seal the leak and prevent further damage or flooding until a permanent repair can be made. Options B, C, and D are incorrect as they do not properly address the leak and could lead to further issues.
Related Questions
Q64:The efficiency and output capacity of a low pressure distilling plant will be re... Q282:Which of the following would represent an attempt to reduce the frequency of req... Q332:If a vessel is to be laid up for an extended period of time with minimal utiliti... Q9:In a compression type automatic grease cup, the lubricant is forced into the bea... Q66:A high reading is indicated at the salinity cells labeled "Y", "Q", and "6" show...
Ready to test your knowledge?
Take a General Subjects - 1st Asst/Chief Practice ExamOfficial Resources