Question 640General Subjects - Assistant Engineer
70% to passIn machine shop practice, a center gage is used for checking the angle of _______________.
Adrill points
Bscrew threads
C60° thread cutting tools
Dscrew thread pitch
AI Explanation
The correct answer is C) 60° thread cutting tools. A center gage is used to check the angle of 60° thread cutting tools, which are commonly used in machine shop practice. This is because the center gage has a 60° angle that can be used to verify the proper angle of the cutting tool, ensuring it is correctly ground and shaped for cutting threads. The other options are incorrect because a center gage is not typically used to check the angle of drill points (A), screw threads (B), or screw thread pitch (D), which are measured and verified using different tools and methods.
Related Questions
Q131:Which device is used to prevent over pressurization of the illustrated distiller... Q96:Small droplets of water entrained in the flashed vapor produced in a flash-type ... Q410:When piston rod packing persists in leaking on a reciprocating steam pump, the ... Q371:Why should the use of metallic or semi-metallic packing hooks or pullers be avoi... Q337:Of the following propulsion modes, which one would operate with a geared-drive f...
Ready to test your knowledge?
Take a General Subjects - Assistant Engineer Practice ExamOfficial Resources