Question 512General Subjects - Assistant Engineer
70% to passWith regards to the American National Screw Thread nomenclature, 'pitch' is the _______________.
Anumber of threads divided by the length of the threaded portion of the screw
Bangle of taper formed by the centerline of the screw and the crests of the thread
Cangle formed by adjacent flanks of a thread
Ddistance between corresponding points on adjacent threads
AI Explanation
The correct answer is D) distance between corresponding points on adjacent threads. The 'pitch' in the American National Screw Thread nomenclature refers to the distance between corresponding points on adjacent threads, such as the crest of one thread to the crest of the next thread. This is the fundamental measurement that defines the spacing of the threads on the screw. The other answer choices are incorrect because they describe different characteristics of the screw thread, such as the angle of the thread (B and C), or the ratio of threads to length (A), but do not specifically define the 'pitch' as the distance between adjacent threads.
Related Questions
Q379:Why is the discharge pressure of a herringbone gear pump steadier than the disch... Q339:What statement is true concerning the ability of a line shaft bearing to adapt t... Q109:Which of the following conditions occurs in the section labeled "F" of the devic... Q376:A pump shaft that is bent or distorted should normally be _______________. Q181:Which of the following statements describes the functions of a reservoir used in...
Ready to test your knowledge?
Take a General Subjects - Assistant Engineer Practice ExamOfficial Resources